Server config question

where do I put the bind statements for IP address/port.

I believe the syntax is:

set net_ip xxx.xxx.xxx.xxx

set net_port xxxxx

do they go on the command line after "exec +server.cfg" or do they go in the cfg file?

TIA

not sure the correct syntax for config. might be seta instead of set.

But if you do it from command line then just add the following:

+set net_IP xx.xx.xx.xx

Post edited by Hoby at 7/18/2002 5:26:08 PM

id just put it in the shortcut, easier to do

"exec server.cfg +set net_ip x.x.x.x +set net_port x"